1. Packaging
Each roll of reflective sheeting should be wrapped with PET film, pasted with sealing tape, and
then suspended in a carton through a bracket. The outer packaging should be marked to prevent
rain, exposure, heavy pressure, and keep away from fire and heat sources.
2. Transportation
Reflective sheeting should be protected from extrusion, impact, sunlight and rain during transpor
tation.
3. Storage
After the reflective sheeting is purchased, it is required to be used within one year.
① The reflective sheeting should be stored in a dry, clean, ventilated room, free of acid, alkali and
other corrosive items, away from humidity, direct sunlight and 2 meters away from heat sources;
② The indoor temperature should be kept at 5℃~35℃, and the relative humidity should not be
higher than 70%. Before use, you must ensure that the reflective sheeting has been placed in an
environment with a temperature of 20-28℃ for 24 hours, otherwise the adhesive performance of
the reflective sheeting will be affected. Influence.
③ When stacking, reflective sheeting must be placed in the same direction according to the
arrows. Boxes must be stacked neatly. The maximum number of stacking layers is 5. Cross stack
ing and mixed stacking of packaging boxes of different sizes are prohibited.
4. Transportation of reflective sheeting
Reflective sheeting should be handled with care to avoid collisions. Before transporting, pay
attention to whether the packaging is damaged. If there is any damage, it should be sealed before
transporting.
① When the used reflective sheeting is rolled, it must be fixed with plastic brackets and then
packed and transported;
② Large-area reflective sheeting can be rolled into a large tube for transportation;
③ Reflective sheeting cut in small areas can be stacked and transported, and the stacking height
should not exceed 5cm, about 100 sheets.
5. Cutting of reflective sheeting
① The cutting environment must be clean to prevent dust and small garbage from being
adsorbed by static electricity on the film. The operating environment must be at a temperature of
20-28℃, indoor humidity not higher than 70%. When the humidity is too low, you can adjust the
indoor humidity by sprinkling water on the ground or using a humidifier;
② The cutting knife must be kept clean and sharp when cutting. The cutting mat can be made of
flat and hard surface. When cutting, the inclination angle between the blade and the film is prefer
ably 10°to 30°. When stacking films of the same shape and size, they should be placed
flat and flat on a flat plate. The stacking height should not exceed 5cm, about 100 sheets. It is
forbidden to contaminate the reflective sheeting with any stains or scratch it with hard objects,
otherwise it will leave obvious marks and ultimately affect its reflective brightness;
③ Due to the relatively high hardness of the reflective sheeting, when the cutting plotter is operat
ing, the cutter head pressure should be set to 400-500g, and the lettering speed should be set to
2-3cm/s. Be sure to check whether the cutter head is sharp before engraving. Use new, Use
better quality and larger cutter heads for engraving operations;
④ Unused reflective sheeting can be packaged in the original packaging and returned to the origi
nal place, or rolled up tightly and erected on a stand. It is prohibited to place it against a wall or
allow the film to come into contact with the film.
Your message must be between 20-3,000 characters!
